Manual Encoder EEV 80

The well established INDUcoder product line of manual pulse generators and hand-held terminals has been expanded to a new device, the robust electronic manual pulse generator MANUAL ENCODER EEV 80.

The particularly reliable STANDARD SHAFT ENCODER EE 58 is used as optical electronic basis. Therefore the following resolutions are available: every number of pulses from 1 to 6,000 and 7,000, 7,200, 7,500, 8,000, 8,192, 9,000, 9,144, 10,000 pulses per revolution.

Supply voltage is available with the following combinations:

5 VDC with RS422 line driver or
10 - 30 VDC with push-pull outputs with 3 or 6 channels or RS 422 line driver.

MANUAL ENCODER EEV 80 with push-pull output is directly connectable to a PLC-controller with 24 Volts inputs.

EEV 80 is connected either by a flange connector or by a cable outlet mounted on the side or on the rear. The standard cable has a length of 1 m. On customer's request longer cables can be assembled.

The manual pulse generator has a mechanical click-stop. It is available with or without crank handle. Diameter of the scale and crank handle is 80 mm.

Due to the high protection class IP 65 and high shock resistance of 100 g, robust manual pulse generator MANUAL ENCODER EEV 80 is especially suitable for rough environmental conditions.

  • Robust electronic manual pulse generator
  • Resolution 1 to 10,000 pulses per revolution - every number of pulses
  • Mechanical click-stop and crank handle
  • Push-pull outputs for direct connection to the PLC
  • Protection class IP 65
  • Cable outlet or connector

Go back

to Top